Skip to main content

S Series Worksurface Firmware Upgrade

To update a new worksurface code in a S series console the procedure is as follows

For one section at a time:
1. Power off
2. Power on while holding down both the 1st and 10th channel mute buttons down until you see the engine icon appear on screen and then release the buttons.
3. Wait until the App starts and you should then see a progress display indicating that the upgrade has started – wait for this to finish
4. Power off again and repeat the above procedure for the next section holding the 1st and 10th channel mutes in that section (Mutes 11 and 20)
5. Wait for the update to finish and power cycle the console again
6. Open the Main Menu > Diagnostics view and check that surfaces report new code Version

Was this article helpful?

0 out of 0 found this helpful