Skip to main content

Quantum 852 Console Software V1889

Download Software

New Features and improvements in Quantum8 since V1879.

  • Master screen menu bar has been repositioned to the lower part of the screen.
  • Meterbridge Status Indicators can now be switched on/off independently from the Master screen status indicators.
  • Macroders assignment list can now show more than 4 assignments.
  • A new macro command located in the System commands list has been added to disable all touch screen response. 
  • Bank Switcher’s touch can be individually disabled from each screen.
  • Solo assign channel also assign screen option has been added for the master sections.
  • A keypad has been added for Global tap tempo values.
  • When Klang is enabled on a stereo channel, the default width is now 60o.
  • Mustard All pass filter phase response is now shown in the Expanded control area EQ.
  • The channel macros panel will show where a channel macro is assigned to.
  • Switcher card detection has been improved.
  • Snapshot panel layout has been adjusted.

Fixes

  • Pre Eq/Dyn aux send pick up point corrected.
  • Aux rotaries and sends on faders were not showing the same values for KLANG send levels.
  • Adding a mono Group in session structure could cause the next stereo group to become mono.
  • Worksurface master fader meter would occasionally show signal when no signal was present.
  • An Access violation could occur when opening the Snapshot recall scope.
  • An Access violation could occur after switching master screen view while changing an FX preset.
  • Mix minus didn’t work on Channels 257+.
  • Odd/Even worksurface Channel TFT displays would occasionally become swapped on power up.
  • Converting sessions to Q8 did not always set the correct screen brightness.
  • When loading a session or shutting down the console, the confirmation box would occasionally not be displayed and the console would appear to be frozen.
  • Using LCD Func > Assign to faders on more than one worksurface would cause the application to Quit.
  • Offline software was continuously writing worksurface connection errors to the log.
  • Tap tempo values were only reporting in 50ms increments.
  • Buss EQ bands 1-4 did not work with Macroders.
  • Fader detent did not work on input channels 257+.
  • Meterbridge meters would not show the correct meter level if the meter type was changed after start up.
  • The application could occasionally freeze and briefly show white screens for a short period before recovering.
  • Insert metering was incorrect on stereo channels when any PPM metering was used.
  • Bank Switcher Snapshot controls were not Firing macros.
  • Switching between Aux pick up points in the expanded control area could cause the console to freeze.

Was this article helpful?

0 out of 0 found this helpful