Skip to main content

Q3 Console Touchscreen Response

The touch response on the Quantum 225 & Quantum 338 console are slightly different to the SD series consoles because of a change over to capacitive touch screens.

 

Screens are hardware calibrated during production therefore it is not possible to re-calibrate the screens by the user. There is no user accessible touch calibration.

 

Previously you could select screen items with pressure from a fingernail, now using the pad of the finger you touch slightly above where you would have on an SD series console. Due to the intended angle of the screens you can no longer programme a deliberate offset. Operators will get used to the slightly different operation.

 

 

Was this article helpful?

0 out of 0 found this helpful